Search found 6 matches

by HaltechNathan
Mon Apr 15, 2013 11:26 am
Forum: Platinum Pro Plug-in
Topic: BKTheta Haltech inconvniences
Replies: 9
Views: 4514

Re: BKTheta Haltech inconvniences

Hi, The hissing sound from the fuel tank is the releasing of pressure as you have mentioned. Early firmware did not have the Evaporative Emissions Control output available. Please update to v1.12 firmware an enable this output. http://img689.imageshack.us/img689/492/evapsetup2.jpg Also check that th...
by HaltechNathan
Tue Jul 31, 2012 11:05 am
Forum: Platinum Pro Plug-in
Topic: genesis coupe + Tomei cams intermittent P0011
Replies: 5
Views: 3170

Re: genesis coupe + Tomei cams intermittent P0011

Dear Need2boost, The P011 error is caused by the camshafts not being within 5deg of the target for more than 30 seconds. Typical causes can be: Incorrect configuration of VCT settings. Incorrect reading of Cam Position. Open or short circuit on Cam Solenoid. Faulty Cam Solenoid. Once the engine is a...
by HaltechNathan
Fri Jun 29, 2012 9:53 am
Forum: Platinum Pro Plug-in
Topic: Genesis coupe PnP won't start
Replies: 5
Views: 2184

Re: Genesis coupe PnP won't start

We might need to change that option as there have been a few people reporting that they needed to change that setting to opposite of what they actually have (Key or Push Button). More than likely your car isn't a USD model? All of the initial testing was performed on USD models and it just so happen...
by HaltechNathan
Tue May 03, 2011 3:21 pm
Forum: Interceptor
Topic: Haltech CAN Modules/IO Expander box 12
Replies: 2
Views: 4186

Re: Haltech CAN Modules/IO Expander box 12

As the Interceptor has CAN functions, (CAN HI,LO) will there be support for the IO expander and the thermocouple amplifier? Do we get a firmware update? The Interceptor does have CAN Hi/Lo pins, but it is not fitted with the required hardware for the CAN expansion devices. Unfortunately at this poi...
by HaltechNathan
Fri Feb 04, 2011 10:33 am
Forum: ECU Manager
Topic: DP Output Fan Control
Replies: 44
Views: 13010

Re: DP Output Fan Control

Dear All, We have managed to increase the number of channels available on the Generic Duty Axis on the Sport series for v1.09. The new axis channels are: Coolant Temperature Air Temperature Roadspeed These channels will allow the user to have finer control for outputs such as thermo fans, water pump...
by HaltechNathan
Mon May 17, 2010 7:20 pm
Forum: Platinum Pro Plug-in
Topic: Two questions about install on an RB20
Replies: 1
Views: 1543

Re: Two questions about install on an RB20

Dear Kevin,

All accessories need to be installed into the rear auxiliary harness. They cannot be installed on the factory harness.

The wideband and MAP Sensor can be connected to either pin 2 or 3 on the auxiliary connector. They are both AVI's.

Cheers,

Nathan.

Go to advanced search