Search found 4 matches

by Screma
Thu Jun 01, 2017 2:30 pm
Forum: Platinum Sprint Series
Topic: Internal map sensor calibration
Replies: 1
Views: 514

Internal map sensor calibration

Hi all. I want to use the internal map sensor for my sprint 500. Everything is hooked up correctly and the engine runs fine but the map is reading incorrectly and not showing any vaccum. Just reads. -0.3 psi whilst idling??? When revved it increases the value further into the negative range?? I am c...
by Screma
Tue Nov 08, 2016 5:49 pm
Forum: Platinum Sprint Series
Topic: Base ignition timing setup issue urgent
Replies: 1
Views: 2819

Base ignition timing setup issue urgent

Hi all. I went and set my base ignition timing on my engine. I done all as i should have except i set it on cylinder 4. I never attempted to start the engine and before realising what i had done and hooked the timing light up to cylinder 1 to do it again. I locked the timing to 0 deg again and to my...
by Screma
Thu Sep 29, 2016 2:17 pm
Forum: Platinum Sprint Series
Topic: IQ3 + USM gear position sensor setup
Replies: 0
Views: 5031

IQ3 + USM gear position sensor setup

Hi everyone. I am setting up my sprint 500 powered turbocharged hayabusa hillclimb buggy. I have the IQ3 dash and racepak USM for some additional channels. I am trying to work out how to set up in the racepak software how to display my gear on the display dash. Currently the sensor is voltage per ge...
by Screma
Thu Dec 13, 2012 12:04 pm
Forum: Platinum Sport Series
Topic: Hayabusa turbo base map
Replies: 0
Views: 637

Hayabusa turbo base map

Hi guys. I have a built hayabusa gen 1 and plan to run a PS 1000 with race pak dash. Plan for the build is to run a Garett GTX3076r turbo. If anyone on here has any info that will help me with setting up the haltech Ecu or has any basemaps that will save me some dyno time, please send it through. An...

Go to advanced search