Search found 5 matches

by dk5293
Fri May 26, 2017 5:08 pm
Forum: E11v2/E8
Topic: 20v 4age - question about trigger and temp sensors
Replies: 3
Views: 852

Re: 20v 4age - question about trigger and temp sensors

Hi Matthew thanks for the reply. I should of clarified im using Yaris 1nz coil on plugs and had direct fire selected. I havent managed to get the car started yet and 99% sure ignition was out by one rotation as all it would do is pop and bang and spit flames out of everywhere. So I changed it to 22 ...
by dk5293
Wed May 17, 2017 10:08 pm
Forum: E11v2/E8
Topic: Haltech e8 AUX output to control 4age vvt solenoid
Replies: 2
Views: 652

Haltech e8 AUX output to control 4age vvt solenoid

Hi, I cannot seem to get the VVT solenoid to switch using the Aux outputs on the Haltech e8. I have tried using PWM out #2 as well as AUX out #1 and my understanding is they switch to ground. The solenoid has 12v provided to it on one side (tapped off the power for the ignition coils and not sure if...
by dk5293
Sat May 13, 2017 4:55 pm
Forum: E11v2/E8
Topic: 20v 4age - question about trigger and temp sensors
Replies: 3
Views: 852

20v 4age - question about trigger and temp sensors

Hi, ive recently wired up a Haltech e8 to a silvertop 4age andjust have have a few things id want to clarify Firstly ive just set up base timing (timing lock 10 degrees) through ignition setup in halwin as well as rotating the dizzy/cas and got it dead on 10 degrees with trigger angle 72 degrees and...
by dk5293
Wed Feb 01, 2017 5:04 pm
Forum: E11v2/E8
Topic: E8 Compatible with Elite 1500 universal Loom?
Replies: 3
Views: 953

Re: E8 Compatible with Elite 1500 universal Loom?

Hi Matthew thanks for the response, ive finally gotten round to tackling this. I think ive managed to figure out all the changes i specifically need to make to the loom, the one last part that has me a bit unsure about is pin 25 on the 34 pin connector (labelled ECR OUT on the elite's wiring diagram...
by dk5293
Fri Sep 16, 2016 4:43 pm
Forum: E11v2/E8
Topic: E8 Compatible with Elite 1500 universal Loom?
Replies: 3
Views: 953

E8 Compatible with Elite 1500 universal Loom?

Hi guys, just want to know whether an E8 will work with a universal elite 1500 loom (with fuse box). Going by the wiring diagrams of both, it looks like they share pretty much the same pinout and wire colours (aside from serial port connection which is expected). And a quick search of the forums bri...

Go to advanced search