tooth offset and trigger for 7mgte with E8

cruzan7m

tooth offset and trigger for 7mgte with E8

Postby cruzan7m » Mon Apr 16, 2007 2:37 am

HI! I have an E8 installed on my 7m. The car starts,but is extremely rich. I curently have the offset at 33.0 and the trigger at 11. i'm running rc engineering 1000cc and a plx wideband. I've taken out as much fuel as possible with no change. When the car starts i'm only pulling 5 inches of vacuum, and nothing but black smoke is coming out of my tailpipe. Does anyone have the correct settings for my engine. I don't know of anyone running a haltech in a toyota 7mgte (straight six turbo). P.S. when i remove fuel the rpms goes up but the car is still rich - 10.0 afrs it pins my wideband to rich! Any help would be greatly appreciated.

Scott1600

.

Postby Scott1600 » Mon Apr 16, 2007 11:30 am

You dont need a base map. You need a tuner. go to http://www.haltech.com under the dealer section to find your local dealer. Or take it to your local dyno shop. spend the extra few bucks and get it done properly.


Return to “Technical Support (from EZboard)”

Who is online

Users browsing this forum: No registered users and 1 guest