Audi Tacho not working

Rotawerx

Audi Tacho not working

Postby Rotawerx » Fri Apr 27, 2007 3:25 pm

It just wanders about at 500ish rpm, and I checked with a scope and found it is pulling low too long, the audi needs 50% duty on tacho signal (I put scope on another one I had access to).
An MSD usnit was mentioned in this thread:
p210.ezboard.com/fhaltech...2048.topic
Which one do I use?
8910, 8910-Esomething, 8920...
Or is there an easier way, or circuit I can make that you may know of.

Thanks, Nigel.

ryanlindenberg

Re: Audi Tacho not working

Postby ryanlindenberg » Sun Apr 29, 2007 10:09 am

call MSD, the can tell you.


Return to “Technical Support (from EZboard)”

Who is online

Users browsing this forum: No registered users and 2 guests