msd input/output setup

puredreamz83

Re: dis 4

Postby puredreamz83 » Thu May 03, 2007 5:15 am

im located in toronto canada

matt510

temp

Postby matt510 » Thu May 03, 2007 6:42 am

your air temp sensor is not connected

thats not preventing your engine from starting though

you most likely have a timing issue - get a timing light out and set the base timing.

puredreamz83

Re: temp

Postby puredreamz83 » Thu May 03, 2007 9:02 am

my air temp is connected maybe wired wrong but its connected.

might be timing ill check and get back to u.

Just a random question but if running direct fire 4 coils per cylinder would u wire the injectors differently from any other fuel mode <i>Edited by: puredreamz83 at: 5/3/07 12:21 pm
</i>

matt510

nope

Postby matt510 » Fri May 04, 2007 2:44 am

Nope wiring of the injectors does not change with ignition setup.

puredreamz83

Re: nope

Postby puredreamz83 » Fri May 04, 2007 9:50 am

so i would have to setup mine injectors the same as my firing order.

In this case, firing order 1-3-4-2:

injector output 1 - piston 1
output 2 - piston 3
output 3 - piston 4
output 4 - piston 2


Return to “Technical Support (from EZboard)”

Who is online

Users browsing this forum: No registered users and 2 guests