3 posts • Page 1 of 1
I went to adjust the throttle pumps on the E11v2 with the updated build 32 firmware using the maps described in the instruction manual, I was surprised to find only a small table with a settings available. I did not have a chance to work with the older version "maps" but this seems as if it will be easier to work with. However, I can find no instructions for setting this. Anyone have any comments/suggestions on this new throttle pump setup?
Thanks. Actually, I've tried opening up those supporting documents several times and keep getting an error message. I'm not sure if it's the computer I work on during the day having the problem. I will try to access the documents on the Haltech site again this weekend from another computer and see if that works.
Who is online
Users browsing this forum: No registered users and 7 guests