Build 32 firmware Throttle Pump settings

Topfun99

Build 32 firmware Throttle Pump settings

Postby Topfun99 » Thu Sep 06, 2007 10:58 pm

I went to adjust the throttle pumps on the E11v2 with the updated build 32 firmware using the maps described in the instruction manual, I was surprised to find only a small table with a settings available. I did not have a chance to work with the older version "maps" but this seems as if it will be easier to work with. However, I can find no instructions for setting this. Anyone have any comments/suggestions on this new throttle pump setup?

Thanks.

crispeed

supporting documents

Postby crispeed » Fri Sep 07, 2007 6:12 am


Topfun99

Re: supporting documents

Postby Topfun99 » Fri Sep 07, 2007 10:57 pm

Thanks. Actually, I've tried opening up those supporting documents several times and keep getting an error message. I'm not sure if it's the computer I work on during the day having the problem. I will try to access the documents on the Haltech site again this weekend from another computer and see if that works.


Return to “Technical Support (from EZboard)”

Who is online

Users browsing this forum: No registered users and 1 guest