Using Halwin 1.71 on an E11. Is there any way to invert the MAP Axis. The Fuel and Spark RPM Axis on the Y axis start with 0 RPM at the top and high RPM at the bottom. I found this counter intuitive when building a Map. Can the Axis Values be inverted in the software, or even in the .INI configuration files? I prefer to have low RPM's at bottom of scale.
Would also be nice to have the X Axis at the bottom of the chart instead of the Top. Any way to change this. I don't mind working with .INI configuration files if it needs to be changed there.
Is it possible to change the KPA MAP scaling so that it uses Gauge Absolute Pressure instead ( sea level = 100 Kpa ) instead of Scientific Absolute Pressure ( Sea level = approx 0 Kpa )TIA
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests