Page 1 of 1

E11v2 with msd dis 4 plus

Posted: Sun Jan 28, 2018 10:10 am
by turbofort
Hi guys,

How i connect the e11v2 with a msd dis 4 plus using individual msd coils in a V6 engine? (300zx Vg30dett)

Re: E11v2 with msd dis 4 plus

Posted: Tue Feb 06, 2018 2:48 pm
by HaltechMatthew
Ignition Output 1 through 6 goes to Cyl 1 through 6. Constant Charge, Rising 3.0ms.

Re: E11v2 with msd dis 4 plus

Posted: Mon Feb 19, 2018 12:05 pm
by BlackBirdSR71
HaltechMatthew wrote:Ignition Output 1 through 6 goes to Cyl 1 through 6. Constant Charge, Rising 3.0ms.


Yes. Found out the hard way on an Audi that the MSD DIS 4 ( and 4 Plus ) will not operate correctly with a Dwell rate of less than 2.5ms . 3.0ms should be ideal.

2.5ms dwell limit is not documented anywhere in MSD site or instructions, but finally found a helpful MSD Tech on Yellow Bullet forum that gave me this info.

Re: E11v2 with msd dis 4 plus

Posted: Wed Feb 21, 2018 3:47 pm
by HaltechMatthew
Correct. Something to do with a break time, but it is not documented. 3.0ms works fine.