Editing Aux Input parameters

BlackBirdSR71
Posts: 30
Joined: Tue Jul 14, 2015 3:41 am

Editing Aux Input parameters

Postby BlackBirdSR71 » Mon Aug 13, 2018 7:59 am

Question about Auxilary Input Parameters. A lot of the groups seem to have no Parameters set. There are no fields to adjust. All that you can select are Normal or Inverted.

I want to set up an LSU Heater control or O2 Heater control on a WB controller, so that the Power Relay will not come on until the engine is running over 500 RPM and set a delay of 20 seconds. This is to protect the O2 heater Ceramic from " Thermal Shock " when the engine is started cold.

How do you enter Parameters, if there are no fields shown?

Return to “E11v2/E8”

Who is online

Users browsing this forum: Google [Bot] and 8 guests