I have had several years E6X on multipoint injection and now changed it to sequential mode.
With multipoint engine always fired on every temperature on first two cranks.
But with seq injection it´s a almost impossible to get started below 70Celsius..
I have tryed very different prime times but nothing seems to help.
Injector wirings are changed to firing order + 1.
If the engine runs and I turn it off and start again in minute or so it fires but after 20 mins no change to get it running again.
What should I look? or what is the best method to alter prime to get engine running?
Thanks for Your help!
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests