Cut the harness

shafezee
Posts: 3
Joined: Wed Jun 21, 2017 5:56 pm

Cut the harness

Postby shafezee » Wed Jun 21, 2017 6:00 pm

Hi all
Ive cut my e6x harness to make it short
After that i have problem with trigger and igniton
When i wire the igniton,it went very hot and burn
And the trigger dont have any reading in halwin.
Ive used the last setup,last time it running well.
I need some help
My motor is sr20vdm

User avatar
HaltechMatthew
Haltech Staff
Posts: 2542
Joined: Tue Feb 07, 2012 11:45 am
Location: Sydney, Australia
Contact:

Re: Cut the harness

Postby HaltechMatthew » Thu Jun 22, 2017 1:36 pm

Replace wiring and wire it correctly. Do this with the power off so you dont burn the next sensor or wiring.
Replace smoking sensor and check that it works
Test ECU
If ECU is not working send it back to be repaired if it is possible to repair.

shafezee
Posts: 3
Joined: Wed Jun 21, 2017 5:56 pm

Re: Cut the harness

Postby shafezee » Tue Jun 27, 2017 2:39 pm

Now i know what the problem is,its the trigger.the ignition channel always on triggered.so how am i suppose to repair it?


Return to “E6X/E6GMX/F10X”

Who is online

Users browsing this forum: No registered users and 4 guests