Bosst readings from ECU with interceptor

Big_Daddy
Posts: 1
Joined: Wed Feb 02, 2011 9:02 pm

Bosst readings from ECU with interceptor

Postby Big_Daddy » Thu Feb 03, 2011 9:21 am

I installed a Haltech interceptor on my mini cooper S and now the boost reading taken from the ECU via a scangauge and datalogging equipement using the OBDII port reads low at 9-10 psi (maximum) however when on the dyno the car reads 15psi of boost (which it was previously to installing the Haltech).
Is this caused by the piggybackunit if so how?

Thanks

Return to “Interceptor”

Who is online

Users browsing this forum: No registered users and 2 guests