Hello everyone! And sorry my bad english (i'm from Finland )
I'm installing a Haltech E6S ECU in my Saab 99 Turbo -1975 and i have a few questions:
I use a basic type trigger with 2 Cherry GS100502 hall sensors: Main trigger on crank pulley with 2 tooth trigger wheel and home sensor on flywheel with one tooth at 85° btdc.
Do I need external pull-up resistor with these Cherry GS100502 hall sensors? https://secure.vilkasgroup.com/WebRoot/vilkasfi01/Shops/2015011209/MediaGallery/Gear-Tooth-Speed-Sensors-Datasheet-GS1005-GS1007.pdf
I think that my old E6S is not include the Motronic-chip, so did that means there is no reluctor adaptor also?
2 posts • Page 1 of 1
- Haltech Staff
- Posts: 2503
- Joined: Tue Feb 07, 2012 11:45 am
- Location: Sydney, Australia
Yes, it wont run reluctor and may have issues in general with missing tooth triggers. I would advise not to use the ECU and look for something much more modern.
Who is online
Users browsing this forum: No registered users and 3 guests