Base Fuel map Load axis question

mack85n
Posts: 11
Joined: Sun Nov 20, 2016 12:10 am

Base Fuel map Load axis question

Postby mack85n » Sun Nov 20, 2016 12:17 am

Hi,

I'm new to using Haltech ECU's as tuning platforms after having always tuned LS engines with HP tuners.
My question is in regards to the load axis and MAP pressure.

On the Haltech software it begins at -100 Kpa and runs through to 0 Kpa for N/A and above into positive Kpa for forced Induction.
HP Tuners load axis begins at 0 Kpa and runs through to 100kpa for N/A engines and above 100 Kpa for forced Induction.

Why is this?

Thanks

JimKden
Posts: 395
Joined: Wed Jan 12, 2011 3:28 am

Re: Base Fuel map Load axis question

Postby JimKden » Sun Nov 20, 2016 1:32 am

Go to Tools / Options and change the units.


Return to “Tuning Discussions”

Who is online

Users browsing this forum: No registered users and 1 guest