distinguish Launch and Flatshift

User avatar
Just2FasTT
Posts: 29
Joined: Fri Oct 23, 2015 6:51 pm
Location: Germany Heilbronn
Contact:

distinguish Launch and Flatshift

Postby Just2FasTT » Mon Nov 30, 2015 11:23 pm

I had some problems when i activate both functions on my elite 1500. If i want to use flatshift at an higher rpm than the launch-rpm it feels like it activates the launchcontroll and if i want to use the launchcontroll it activates the flatshift first for the milliseconds i set and afterwards the launch.

I have used a N2MB Wotbox with my stock ECU it distinguishes both functions by the first pedal pressed. If i press the clutch first it would be launch and if i press the accelerator pedal first over the treshold it would be Flatshift.
Also the Wotbox was cutting the Ignition completely so there was no rising rpm on flatshift. I haven´t found a way to do this with my elite, even with Ignition cut or retard my engine revs up a little to much.

I think this could be easy for you guys to attach to a newer firmware if its usefull

User avatar
HaltechMatthew
Haltech Staff
Posts: 2478
Joined: Tue Feb 07, 2012 11:45 am
Location: Sydney, Australia
Contact:

Re: distinguish Launch and Flatshift

Postby HaltechMatthew » Tue Dec 01, 2015 9:52 am

Send the map and I will check it out.


Return to “Feature Requests”

Who is online

Users browsing this forum: No registered users and 3 guests