2JZGE backfiring won't start 36-2+1

Questions about the Platinum Sport series ECU settings or features? Ask here.
nismotunedgtr
Posts: 1
Joined: Tue Jan 23, 2018 1:33 pm

2JZGE backfiring won't start 36-2+1

Postby nismotunedgtr » Tue Jan 23, 2018 1:54 pm

Looking for some help with my current project car.

After a few sets of plugs and many many hours, I still can't get my Supra to run.

At the most I get a backfire out the intake or the exhaust.

Here's a few details:

2jzge
Factory 36-2 crank sensor
7mgte cam sensor with all but one tooth cut off the trigger wheel
800cc injectors
S366
1zz coils

I've tried a million tooth offset and trigger angle combinations, every time I get the crank pointer dead nuts on..... no start.

I have the software set for 36-2+1

I've been through and verified the harness four times.

Any and all help is EXTREMELY appreciated! Thanks!

User avatar
HaltechMatthew
Haltech Staff
Posts: 2578
Joined: Tue Feb 07, 2012 12:45 pm
Location: Sydney, Australia
Contact:

Re: 2JZGE backfiring won't start 36-2+1

Postby HaltechMatthew » Tue Feb 06, 2018 3:29 pm

With a factory 36-2 on the crank and a Sport series ECU there are only two possible values to make it run depending on which cycle your cam tooth appears.

Reluctor / Falling for the sensors if the wiring polarity is correct. If unsure then a cheap scope will show this.

Trigger angle is 65

Tooth offset either 9 or 45 (9 + 36)

1ZZ coils are Constant Charge with Falling edge and charge around 3ms


Return to “Platinum Sport Series”

Who is online

Users browsing this forum: No registered users and 10 guests