by turboii » Tue Mar 09, 2010 10:37 am
by vamian » Wed Mar 10, 2010 8:56 am
by turboii » Wed Mar 10, 2010 11:39 am
by hustleShark » Thu Mar 11, 2010 4:15 am
by vamian » Thu Mar 11, 2010 6:58 am
by turboii » Thu Mar 11, 2010 12:36 pm
by _aatsi_ » Thu Mar 11, 2010 2:32 pm
by Robbks » Wed Mar 17, 2010 10:59 am
turboii wrote: I modify the spark plug wires to fit, since the older coil has different connectors, hook them up, hook up a timing light to zero it. .. and back to no spark.
by eranmk1 » Wed Aug 03, 2011 2:57 pm
turboii wrote:I am trying to get a ps1000 working with a '99 impreza coil/ignitor. I am not sure about the wiring, but it has 4 wires and from what I can gather from the impreza FSM the wiring is this:
1. Coil 1 input (cyl 1, 3)
4. Coil 2 input (cyl 2, 4)
but it does not work, i get no spark. I was previously running this car with the older coil setup (separate coil and ignitor modules) and it ran fine, so i know my settings are right as far as trigger, and i am getting rpm reading when cranking. But i swapped the old engine out for a newer EJ22, and it came with this newer coil pack that has a coil with built-in ignitor.
Does anybody know how to wire it up?
thanks for the help