I moved this from the Sport group to here.
I updated my desktop PC to ECU manager 1.13 and when I bring my map in from my laptop PC (1.08), my map psi tables only go to -11.9. Columns changed below 0 psi.
I'm hesitant to update my laptop to 1.13 not knowing if the same thing will happen and screw up the data.
I can't find the old 1.08 file, so I can't go backwards in the desktop.
Any help?
I reloaded my 1.08 to my desk top and loaded my working map from my laptop.
I just tried to change my fuel axis to a renamed axis in my laptop. It won't accept a new axis. The "enable axis" box remains grayed out.
I can't extend the -psi range to below what is displayed in the table.
I'm stuck.
FUBARed my ECU Manager?
- HaltechMatthew
- Haltech Staff
- Posts: 2676
- Joined: Tue Feb 07, 2012 12:45 pm
- Location: Sydney, Australia
- Contact:
Re: FUBARed my ECU Manager?
Post the map
Re: FUBARed my ECU Manager?
Matt, did you get a chance to look at my map?
Re: FUBARed my ECU Manager?
Here's what I get when I open the map with 1.13. What's the problem?


Haltech Parts and Accessories
Custom Harness Construction
http://www.lms-efi.com
chris@lms-efi.com
502-515-7482
Custom Harness Construction
http://www.lms-efi.com
chris@lms-efi.com
502-515-7482
Re: FUBARed my ECU Manager?
That is what I expect to see, but I get this (see attachment) in either 1.08, 1.12 or 1.13. BTW, how do you paste the map in this reply?
The table from 0psi only goes to 11.9 and all the values have changed. Plus I can't change it in table setup. I get "Value must be between the max and min values".
The table from 0psi only goes to 11.9 and all the values have changed. Plus I can't change it in table setup. I get "Value must be between the max and min values".
Re: FUBARed my ECU Manager?
I have the units in psi/hg. You have them set to straight psi. No difference in the map. Just the units. Every time you update the software, it resets to the default and you need to manually reconfigure. Set yours to psi/hg and they'll be the same.
Haltech Parts and Accessories
Custom Harness Construction
http://www.lms-efi.com
chris@lms-efi.com
502-515-7482
Custom Harness Construction
http://www.lms-efi.com
chris@lms-efi.com
502-515-7482
Re: FUBARed my ECU Manager?
That was it! Thank you.
- Claudio
- Posts: 1188
- Joined: Wed Sep 26, 2007 10:44 am
- Location: Santo Domingo, Dominican Republic
- Contact:
Re: FUBARed my ECU Manager?
On a side note. If you try to change a value for an axis load or rpm point and the value is already there it wont let you and give that error message, if the full resolution of the table is enabled (32x32), you wont be able to add new values.
Who is online
Users browsing this forum: No registered users and 1 guest