datalog mark

Questions about ECU Manager? Ask here.
Vicoor
Posts: 23
Joined: Mon Apr 29, 2013 11:35 am
Location: Manassas, Virginia

datalog mark

Postby Vicoor » Tue Sep 09, 2014 4:19 am

I'm using a PS1000 and ecu manager software.

When datalogging to a PC, is there some way to create a reference mark in the log so I can go back to that spot without extensive searching.

Thanks,
Victor
Don't talk about it, Just Do It!

LMS_689
Posts: 1397
Joined: Thu Oct 18, 2007 6:30 am
Location: Floyds Knobs, IN USA
Contact:

Re: datalog mark

Postby LMS_689 » Wed Sep 10, 2014 6:29 pm

You could install a switch on a digital input to trigger something that isn't actually used. Say AC Request in a car without AC. The normal state would be off and then cycle it on/off with a toggle to place a reference mark in the log.
Haltech Parts and Accessories
Custom Harness Construction
http://www.lms-efi.com
[email protected]
502-515-7482

Vicoor
Posts: 23
Joined: Mon Apr 29, 2013 11:35 am
Location: Manassas, Virginia

Re: datalog mark

Postby Vicoor » Thu Oct 09, 2014 7:05 am

Thanks for the reply.

I was hoping you'd tell me there is a keystroke command for marking the datalog.

Seems like a waste to use up an input for that.

I'm more familiar with the MS family of EMS, and the tuning software they use.

Thanks again.

Victor
Don't talk about it, Just Do It!


Return to “ECU Manager”

Who is online

Users browsing this forum: No registered users and 2 guests