Internal map sensor calibration

Questions about the Platinum Sprint series ECU settings or features? Ask here.
Screma
Posts: 5
Joined: Thu Dec 13, 2012 8:03 am

Internal map sensor calibration

Postby Screma » Thu Jun 01, 2017 2:30 pm

Hi all. I want to use the internal map sensor for my sprint 500. Everything is hooked up correctly and the engine runs fine but the map is reading incorrectly and not showing any vaccum. Just reads. -0.3 psi whilst idling??? When revved it increases the value further into the negative range??

I am convinced that its a calibration issue but the software will not let me change the map calibration table?? Any ideas?
Attachments
2.jpg
1.jpg

User avatar
HaltechMatthew
Haltech Staff
Posts: 1978
Joined: Tue Feb 07, 2012 11:45 am
Location: Sydney, Australia
Contact:

Re: Internal map sensor calibration

Postby HaltechMatthew » Tue Jun 06, 2017 3:05 pm

The calibration is not adjustable. I would be checking where you are sourcing the MAP signal, that it is not from a ported source in a throttle body.


Return to “Platinum Sprint Series”

Who is online

Users browsing this forum: No registered users and 1 guest