Sprint 500 CAS issue 1G eclipse/DSM

Questions about the Platinum Sprint series ECU settings or features? Ask here.
Coldest
Posts: 4
Joined: Sat Apr 15, 2017 1:07 pm

Sprint 500 CAS issue 1G eclipse/DSM

Postby Coldest » Sat Apr 15, 2017 3:46 pm

Hello, I just upgraded from an E6X to a sprint 500 on my 1G DSM/Eclipse and I get a initial spark when I key it over, but nothing while cranking. I am also not getting any home counts or trigger counts. I am using The red wire to power it, The blue wire to ground it, And the yellow(trigger +) from the 4 core trigger input cable. I am using green(Home -) from the 4 core home input cable. I hooked up the CAS the same way I had it with the E6X But I am not having any luck. Thanks for any insight.

Coldest
Posts: 4
Joined: Sat Apr 15, 2017 1:07 pm

Re: Sprint 500 CAS issue 1G eclipse/DSM

Postby Coldest » Sun Apr 16, 2017 3:43 am

Trigger setup
Standard full cycle
hall effect
hall effect
rising
rising

Coldest
Posts: 4
Joined: Sat Apr 15, 2017 1:07 pm

Re: Sprint 500 CAS issue 1G eclipse/DSM

Postby Coldest » Sun Apr 16, 2017 3:51 am

wiring to CAS from left to right
Pin 1 green Home - from home cable
Pin 2 Yellow trigger+ from trigger cable
Pin 3 Red +12V from trigger cable
Pin 4 Blue Ground wire from trigger cable

I have to be missing something... The CAS worked fine with my E6X... Maybe I just need a good base map?

Coldest
Posts: 4
Joined: Sat Apr 15, 2017 1:07 pm

Re: Sprint 500 CAS issue 1G eclipse/DSM

Postby Coldest » Sun Apr 16, 2017 4:44 am

Ok, So I used the yellow home(+) wire instead of the green(-) one now it gives me signal.


Return to “Platinum Sprint Series”

Who is online

Users browsing this forum: No registered users and 3 guests