Questions about the Platinum Sprint series ECU settings or features? Ask here.
2 posts • Page 1 of 1
Im having problems starting my engine using a sprint re. Im getting spark, and fuel but fuel injectors are not firing. (injectors have 12v) I checked wiring to the cas and compared to the wiring diagram, its good. almost everytime I restab the cas, itll have a long crank and run for a bit then die. A while back I had a faulty connection at a bulkhead harness connector and some wires shorted out which leads me to believe the haltech might be bad? I replaced the harness and skipped the bulkhead connector. Anyway, under the diagnosis page, trigger reads about 300 more than home, I dont know if thats normal. whenever I crank the engine, the haltech casing is warm/hot. I dont know what else to check? grounds are good.
Who is online
Users browsing this forum: No registered users and 4 guests