I'm hoping someone can give me some help with my ap1 running platinum pro plug-in.....
I am having an issue with my canART multifunction gauge. I have it connected to the car via the included can cable that goes into the last #3 slot of of my can hub (with the resistor as it's the last item in the chain) and the I/O expander is in the #2 port (white CAN CABLE) and the #1 port goes to my ecu ( via black CAN cable). When powered on, the ecu won't detect the I/O box and the gauge continuously drops wifi connection nor will make a wifi connection to my phone, and additionally it only displays 'progamming mode" the entire time it's connected. Removing it and running only the can hub and the I/O box (using both black cables) the ecu detects the expander box and works as it should but if I disconnect the I/O box and use only the can gauge (also using only black cables) it still won't allow any wifi connection and only displays "programming mode" I believe the gauge is defective as all the items are new but have no other means of troubleshooting. Any help you can provide is greatly appreciated
Questions about the Platinum Pro Plug-in ECU's? Ask here.
2 posts • Page 1 of 1
Not sure on your cables connections because it's been a while since I installed mine. But the resistor is not used unless you have multiple gauges connected together and then going to the expander/HUB. I have dual wideband and canart gauge in the mini hub that's connected to the ecu. I did not use the resistor. Not sure that's your problem though.
Who is online
Users browsing this forum: No registered users and 4 guests