Need help with platinum pro and canART gauge

Questions about the Platinum Pro Plug-in ECU's? Ask here.
Posts: 3
Joined: Sat May 19, 2018 2:53 pm

Need help with platinum pro and canART gauge

Postby Ap1hero » Sat May 19, 2018 3:03 pm

I'm hoping someone can give me some help with my ap1 running platinum pro plug-in.....

I am having an issue with my canART multifunction gauge. I have it connected to the car via the included can cable that goes into the last #3 slot of of my can hub (with the resistor as it's the last item in the chain) and the I/O expander is in the #2 port (white CAN CABLE) and the #1 port goes to my ecu ( via black CAN cable). When powered on, the ecu won't detect the I/O box and the gauge continuously drops wifi connection nor will make a wifi connection to my phone, and additionally it only displays 'progamming mode" the entire time it's connected. Removing it and running only the can hub and the I/O box (using both black cables) the ecu detects the expander box and works as it should but if I disconnect the I/O box and use only the can gauge (also using only black cables) it still won't allow any wifi connection and only displays "programming mode" I believe the gauge is defective as all the items are new but have no other means of troubleshooting. Any help you can provide is greatly appreciated

Return to “Platinum Pro Plug-in”

Who is online

Users browsing this forum: No registered users and 5 guests