R34gtt iat sensor fixed, fuel pump ground control issue

Questions about the Platinum Pro Plug-in ECU's? Ask here.
Rustyrbz
Posts: 1
Joined: Mon Jun 11, 2018 3:11 am

R34gtt iat sensor fixed, fuel pump ground control issue

Postby Rustyrbz » Tue Jun 12, 2018 2:11 am

Hello, new to the forum. First time using haltech.

Vehicle info:
Datsun 260z
Rb25det neo
Gm open element air temp sensor.

I have the iat sensor wired in to avi1 with pull up enabledif I use the supplied file for gm iat the gauge on screen<ecu manager> shows 14° and cel is on for high voltage.If I disable the pull up resistor I get the same thing.I put in a shortened vision of the aem calibration and it showed ..
--FIXED- thanks

Having issue with fuel pump ground control. With fuel pump priming pulse set to 3 seconds, when the key is turned the ground trigger stays on as does the relay until you turn the key back off
Any suggestions would be

JimKden
Posts: 376
Joined: Wed Jan 12, 2011 2:28 am

Re: R34gtt iat sensor issues

Postby JimKden » Tue Jun 12, 2018 4:35 am

No pull up used on the sensor.
Is the sensor ground wire connected to the ecu signal ground ?


Return to “Platinum Pro Plug-in”

Who is online

Users browsing this forum: No registered users and 5 guests