R32 GTR - Can hub w/ wb1 and can gauge art via can hub

Questions about the Platinum Pro Plug-in ECU's? Ask here.
Kyath1
Posts: 1
Joined: Tue Sep 18, 2018 11:43 pm

R32 GTR - Can hub w/ wb1 and can gauge art via can hub

Postby Kyath1 » Tue Sep 18, 2018 11:55 pm

Hi - I tried installing a can hub to run a can gauge and WB1 plug in. I am not getting any readings at the gauge. When loading the ecu manager, it reads the wb1 and ecu runs fine. However, gauge is not reading any measurements. I have the resistor in place since it’s the last in the chain.

Can hub set up:
Slot 1 is ECU with black/black
Slot 2 is WB1 with white/white
Slot 3 is Can gauge with tyco adapter harness with black end - terminator resistor is in place.

What am I missing to get this gauge to read?

Ecu is R32 GTR platinum pro plug in.

Return to “Platinum Pro Plug-in”

Who is online

Users browsing this forum: No registered users and 6 guests