Page 1 of 1

Elite 750 VW Base Map

Posted: Thu Jun 08, 2017 2:00 pm
by Turbo69Bug
Hi All,
Just about finished the upgrade from E6A to Elite 750 but will soon have to get the old girl fired up. Trouble is I have no way to get the old maps from the E6A or the .......floppy disc...... they are stored on, to use as a comparison.
It is a pretty simple setup but any suggestions for a Base Map?
Engine is -
Air Cooled VW
Turbo 4 Cyl 2178cc
Electronic Dizzy with Single Coil and Bosch Igniter
TPS
MAP

Thanks in advance

Re: Elite 750 VW Base Map

Posted: Thu Jun 08, 2017 2:10 pm
by HaltechMatthew
It is not a fixed common set of hardware for anyone to have a specific base map. Firing it up is something any tuner should be able to do for you and if it takes them more than 5 minutes you need to go somewhere else.

You can manually copy over the settings from your old E6A to get it going yourself though. The terminology is similar.

Re: Elite 750 VW Base Map

Posted: Thu Jun 08, 2017 4:52 pm
by Turbo69Bug
Thanks Matt.

I am more looking to just get the car started to check everything is working and nothing is leaking before sending to the tuner.

Re: Elite 750 VW Base Map

Posted: Mon Jun 19, 2017 6:17 pm
by keet45
Howdy! What solution did you came up with to compare the maps?

Re: Elite 750 VW Base Map

Posted: Tue Jun 27, 2017 7:39 am
by Turbo69Bug
I actually didn't, I just started again.
As Matt said, once I got the ESP set up with all of the engine specs it was enough to get it started and drive-able.
I just have to figure out why it is firing 180 degrees out though. That was an unexpected headache which had me thinking for a while. Moving the leads around the cap was the short term solution to that though.