Can't start up 4age 20v with elite 550

Questions about the Elite Series ECU's? Ask here.
pedrolopeznoe
Posts: 1
Joined: Sun May 27, 2018 12:24 am

Can't start up 4age 20v with elite 550

Postby pedrolopeznoe » Sun May 27, 2018 12:35 am

Hello everyone I hope you can help me with this problem, this is the case.

Last year in the workshop where I work we built a 20v 4age with a platinum sprint 500, it was very difficult to me, because it was my first time tunning a car and I had it to read a lot in a lot of forums. Finally the car can start up and everything is working ok to today !

This week I built another 20v 4age but this time with a haltech elite 550, using the same functions, same base map to start up and the same standard igniter, coil and distributor, I checked the harness a lot of times and its ok, I use the same harness to start up the other 4age that we have in the workshop and it's ok, the harness its not the problem. I have spark in each cilynder and fuel in injectors .

Using the standard computer of the 4age the car can start up.

I calibrated the firing angle using the lock mode with the timing light to 0 degrees like in the other car.

So can someone tell what more to do ? Because the next weekend we have a race and the car cant start up.

I'm attaching my setup

Thanks !
Attachments
elite-4ag-3.png
elite-4ag-2.png
elite-4ag-4.png

Hacktacular
Posts: 17
Joined: Sun Jun 04, 2017 5:27 am

Re: Can't start up 4age 20v with elite 550

Postby Hacktacular » Sun May 27, 2018 7:50 am

Try unchecking "enable flood clear mode"
Also, you have 300,0 kpa for fuel pressure.
I don't think that is right. Take the comma out...


Return to “Elite Series”

Who is online

Users browsing this forum: No registered users and 5 guests