Hoping someone here can help.
I’m fitting a Haltech Elite 2500 to a 2GR V6. It’s all wired up and will run but I’m not getting a home signal. Wiring has been checked and is good.
I called the Kentucky office yesterday and the guy said that the 2GR CAS needs custom selected in type due to the output being 3V rather than the 5V the ecu is looking for. He was going to email me the settings but I’ve not received them (either not sent or wrong email address)
Does anyone have these or tell me how to go about working it out?
It’s a Hall effect sensor.
Questions about the Elite Series ECU's? Ask here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests