Dbw calibration problem

Questions about the Elite Series ECU's? Ask here.
Mitchell91
Posts: 2
Joined: Wed Aug 29, 2018 7:45 pm

Dbw calibration problem

Postby Mitchell91 » Wed Aug 29, 2018 8:35 pm

Hi

I have an elite 2500 ecu
I’m trying to get a Bosch 70mm throttle body to work (from a vz commodore)
The issu is when finding the limits during calibration the throttle body moves roughly 5-10 degrees. But the ecu is recording tps values fluctuating between 30% and 100%
Not matching what the tb is actually doing

The software will not go past the regression.

I have checked 5v contamination with earth, tried removing all other signal ground connections.
Checked 5v supply.
Triple checked wiring for both tps
Had someone else check the wiring
And tried three two other throttle body’s

I have emailed Haltech, but got no response yet so I thought I’d see if anyone else has overcome this problem before I give up and go back to a cable throttle..

All wiring is done as per Haltech a suggested pins

Thanks

User avatar
Drwaffles
Posts: 68
Joined: Sat Jul 28, 2018 11:51 pm

Re: Dbw calibration problem

Postby Drwaffles » Sun Sep 02, 2018 12:47 am

Silly question, but have to tried a spare throttle body to confirm there's nothing wrong with the one you're using?

Mitchell91
Posts: 2
Joined: Wed Aug 29, 2018 7:45 pm

Re: Dbw calibration problem

Postby Mitchell91 » Sun Sep 02, 2018 5:27 pm

Yes I have tried 2 others

Mobne_s13
Posts: 268
Joined: Sun May 25, 2008 8:56 pm

Re: Dbw calibration problem

Postby Mobne_s13 » Wed Sep 05, 2018 7:53 pm

I had a issue with my M3 ITB:s not opening 100% When the calibration was done.
Actual opening was more line 90%.

For me it turned out that the springs made too much resistance for the motor, I guess that the current Haltech gives out to Dbw is leas than what bmw delivers making the motor weaker.

(Completely std Dbw setup)

I solved it with removing the throttle spring from 2 of the throttles and it worked.

Maybe not the problem for you but I wanted to share info anyways.

ylnoecar
Posts: 1
Joined: Tue Oct 23, 2018 6:08 pm

Re: Dbw calibration problem

Postby ylnoecar » Tue Oct 23, 2018 6:10 pm

Did anyone figure this out?
Ive got the same throttle body and the exact same issue. Throttle body voltages jumping around. When checked with a multimeter the tps voltage is stable but the ecu shows voltages going as low as 1v and as high as 2v on the tps inputs.

User avatar
HaltechMatthew
Haltech Staff
Posts: 2542
Joined: Tue Feb 07, 2012 11:45 am
Location: Sydney, Australia
Contact:

Re: Dbw calibration problem

Postby HaltechMatthew » Wed Oct 24, 2018 9:34 am

Just be sure you are only using AVI2,3,4,5 for the position sensors, but it sounds more like you have a signal wire mixed with a 5V or a ground. These throttle bodies have been used many times and should just work like any other throttle.


Return to “Elite Series”

Who is online

Users browsing this forum: No registered users and 5 guests