I run a single brushless 1800 hp fuel pump set up from fuel labs,irun a dpo to the pump and at very low part trottle ,sometimes the dpo cuts out for a split second and turn the fuel pump off,all settings are good,can t figure that out anyone could give me a hint ?
the dpo table for the fuel pump are -29 ag to 35psi vs rpm 0 to 9500
only happens if you go very faintly go into the trottle,low load I run the the dpo at 40 % and I can see on my guage that the dpo shows 0% for a split second
Questions about the Elite Series ECU's? Ask here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests