Hello
Im browsing over the help files, and I find this as an OPTION for IDLE CONTROL
________________________________________
Ignition Only
Suitable for vehicles without a Drive By Wire throttle or Idle Air Control Valve.
________________________________________
But when I go to the Idle control settings on Haltech ESP, I only get the following options
-BAC Two Wire
-BAC Three Wire
-Stepper Motor (absolute)
-Stepper Motor (relative)
-DBW
Im wondering if this option is only avaliable for certain Elite models (im using Elite 1500 firmware 2.24.0)
best regards
Idle Control with spark corrections
- blakebonkofsky
- Posts: 252
- Joined: Sun Aug 02, 2015 2:58 am
Re: Idle Control with spark corrections
Ignition Only idle control was added in firmware 2.27. You would just need to upgrade FW to use it.
-
- Posts: 2
- Joined: Fri Oct 26, 2018 3:44 am
Re: Idle Control with spark corrections
blakebonkofsky wrote:Ignition Only idle control was added in firmware 2.27. You would just need to upgrade FW to use it.
yeap, I just noticed that we are already at 2.28. My bad

Who is online
Users browsing this forum: No registered users and 1 guest