Calibration for HT-010306 or HT-010304

Questions about the Elite Software Programmer? Ask here.
EvilEvolution8
Posts: 55
Joined: Wed Dec 07, 2016 10:37 pm

Calibration for HT-010306 or HT-010304

Postby EvilEvolution8 » Tue Nov 13, 2018 10:07 pm

Hello Guys,
Is possibile to have the calibration for these sensors in Ohms ?

In the pdf specs there is a pinout...but i think that is not mandatory to respect the pinout right? normally in NTC sensor the pinout is not relevant..

Thanks
Best Regards

JimKden
Posts: 395
Joined: Wed Jan 12, 2011 3:28 am

Re: Calibration for HT-010306 or HT-010304

Postby JimKden » Wed Nov 14, 2018 7:10 am

You can develop your own values either resistance if you have the voltage for temperatures cal or the voltage if you have a sensor with no cal but can arrive at the resistance for various temperatures with the following formula. Create a simple spreadsheet is the easiest way to lay them out for future use.
Attachments
20181113_125308.jpg


Return to “Elite Software Programmer (ESP)”

Who is online

Users browsing this forum: No registered users and 1 guest