No spark or injection for Elite 1500 on honda s2000

Questions about the Elite Software Programmer? Ask here.
s2000elite
Posts: 2
Joined: Sun Aug 06, 2017 10:52 pm

No spark or injection for Elite 1500 on honda s2000

Postby s2000elite » Sun Aug 06, 2017 10:57 pm

HI matthew,

I've set up a new map on the Elite 1500. Upgraded firmware.

Application is a honda S2000. Using a boomslag conversion harness.

running on VE for fuel.
Load type is TPS for Individual throttles.
Map correction enabled.
Wiring is correct. Double checked.
Trigger setup for Honda K20 with no trigger erros and reading RPM ok.

Not getting any spark or injection.
In diagnostic, shows no injection duty cycle while cranking.

Seems the Elite 1500 isn't sending out the ground signals to the injectors or the sparkplug.

Have i done some settings wrong and disabled these outputs?

s2000elite
Posts: 2
Joined: Sun Aug 06, 2017 10:52 pm

Re: No spark or injection for Elite 1500 on honda s2000

Postby s2000elite » Mon Aug 07, 2017 12:15 am

no worries, found the problem. The boomslang harness only had a switched input into connector B and left out the constant 12v in. Wired in the constant 12v and it fired up fine.

thanks


Return to “Elite Software Programmer (ESP)”

Who is online

Users browsing this forum: No registered users and 3 guests