Hi all. I want to use the internal map sensor for my sprint 500. Everything is hooked up correctly and the engine runs fine but the map is reading incorrectly and not showing any vaccum. Just reads. -0.3 psi whilst idling??? When revved it increases the value further into the negative range??
I am convinced that its a calibration issue but the software will not let me change the map calibration table?? Any ideas?
Questions about the Platinum Sprint series ECU settings or features? Ask here.
2 posts • Page 1 of 1
- Haltech Staff
- Posts: 2203
- Joined: Tue Feb 07, 2012 11:45 am
- Location: Sydney, Australia
The calibration is not adjustable. I would be checking where you are sourcing the MAP signal, that it is not from a ported source in a throttle body.
Who is online
Users browsing this forum: No registered users and 2 guests