I have e6x in my car running a 3sgte 2nd gen wth motronic wheel 60-2, 550cc injectors and 4 lsx coils on waste spark.
settings set to Direct fire, Multiport injection.
Been running great until I rebuilt motor. Now it runs on 2 cylinders (2 and 3). there is no spark on cyl 1 and 4. compression is good, injectors all firing, I swapped wires and 1 and 4 and 2 and 3 and coils test good with spark. I noticed that the wires from e6x for coils 1 and 4 show no voltage and wires for coils 2 and 3 show 10.2 (battery was a bit low from cranking). Appears that ign output to coils 1 and 4 is bad? any insight advice would be greatly appreciated.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests