base mape for a EF falcon

ismasiv
Posts: 31
Joined: Fri Jul 29, 2011 11:24 pm

base mape for a EF falcon

Postby ismasiv » Fri Sep 28, 2012 6:48 am

hi i'm just looking for a base map for my EF just to get it going to i can take it to the dyno.. any help would be great :?

Mr tss
Posts: 11
Joined: Tue Jan 09, 2018 9:23 pm

Re: base mape for a EF falcon

Postby Mr tss » Sat Jan 13, 2018 10:04 pm

Any luck on the base mape mate?
Im in the same position with mine.

BLSTIC
Posts: 3
Joined: Sun Oct 30, 2016 2:16 am

Re: base mape for a EF falcon

Postby BLSTIC » Tue Jan 30, 2018 3:33 pm

To get a *functioning* base VE map there's an old Megasquirt online tool

http://www.megamanual.com/v22manual/vetable.htm

It needs assumptions on horsepower & rpm, torque & rpm, idle vacuum, idle speed, redline, and boost, along with displacement

It's not truly accurate, but I've used it a couple of times, scaled it up until peak torque rpm at zero boost/vacuum was 100%, ran ignition timing numbers adapted from similar engines (retarded slightly), and they haven't blown up under racing conditions.

I by no means condone using this as a permanent tuning solution, it needs to be done properly as soon as possible. I only used this under racing conditions because I was tuning cars that had literal guess-maps that were unsurprisingly bad almost everywhere but still hadn't blown up yet and I was asked to help out when I mentioned I had *some* knowledge of tuning.

Unless you mean a base map to suit the interceptor? Which *should* be zero everything for stock, no?

User avatar
HaltechMatthew
Haltech Staff
Posts: 3304
Joined: Tue Feb 07, 2012 12:45 pm
Location: Sydney, Australia
Contact:

Re: base mape for a EF falcon

Postby HaltechMatthew » Tue Feb 06, 2018 3:52 pm

With nothing in the tables it will do exactly what the factory ECU did. These are signal-bending units, not standalone units.


Return to “Interceptor”

Who is online

Users browsing this forum: No registered users and 1 guest