I have an elite series 2000 and I'm not successfully able to get the logs to convert into Virtual Dyno. I get the Run Message "No wide open throttle TPS data found.
Do you want to close this log?"
I'm not able to progress from that point.
I do notice that on the left-hand side of the "Opened Runs" box there's a Haltech stamp, which makes me think it's recognizing the .csv I've imported but something related to formatting perhaps isn't right. I am able to open the log itself by clicking on the link within the program "Show Raw Data" so I feel like it's getting imported, but the program isn't effectively reading the log.
Does anyone else have any problems? Anyone having success that would mind sharing a log with me and let me compare my logs to see if there's a noticeable difference?
I don't have any problems opening the same log in the Haltech datalog viewer software, so I don't suspect file corruption, etc.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest