Thermofan Control

Postby **redcycle13** » Fri Sep 29, 2017 5:53 am

It would be nice to have additional control over the thermofan. Maybe a table option so you could map it over a few variables. It's annoying to be tuning a car with the engine off, and the fan just keeps running because of coolant temp control only. A timer setting if engine rpm is zero would work fine. I guess it could be mapped as a generic output.

Postby **HaltechMatthew** » Thu Oct 05, 2017 3:23 pm

There is already a request to allow a min RPM option, but I doubt it will go to table.

Postby **Jmsmotorsport** » Sat Nov 24, 2018 4:14 pm

Also other input control ie trans temp to control trans cooler thermo.

Postby **aus jd 2703** » Thu Nov 29, 2018 12:27 pm

you can set it up as a general output and map a table.
i did this so the fan would be on when on turbo timer even if its cooler than set point,
you loose the hysteresis but in the short term this may help.