Cam control diagnostics tab

User avatar
Drwaffles
Posts: 134
Joined: Sat Jul 28, 2018 11:51 pm

Cam control diagnostics tab

Postby Drwaffles » Wed Dec 19, 2018 8:56 am

Had a situation where a suspected sensor started playing up and the car was driving like crap. Plugged in the laptop and it said no signal on cam bank 2. Restarted the car and that fixed it oddly, but Ive replaced the sensors anyway.

I noticed there's no engine protection or diagnostic CEL tab for cam control, without the laptop you could drive for an indefinite amount of time with one bank or both having zero cam control and not be aware of any issues.
Personally I reckon you should be able to trigger a CEl If there's a non numerical value in cam angle, would be nice to see Implemented.

Mobne_s13
Posts: 396
Joined: Sun May 25, 2008 8:56 pm

Re: Cam control diagnostics tab

Postby Mobne_s13 » Sat Apr 27, 2019 3:34 am

I have asked this before. To have engine protection on cam control.

My setup often loses the exhaust cam. Engine runs bad.
Bmw have engine protection if Vanos fails. Can’t see how this still is not possible on haltech. Cam control is a vital function and it needs to be correct.

I would like to set dtc if cam error is at X value for X time.


Return to “Feature Requests”

Who is online

Users browsing this forum: No registered users and 1 guest