Replacing my ancient Haltech on a 5-cyl Turbo


Replacing my ancient Haltech on a 5-cyl Turbo

Postby QuantumProject » Thu May 11, 2006 8:42 am

I have a 1987 VW Turbo Quantum with an Audi 5-cyl turbo engine. The current Haltech F3 is dying. I want to replace both the EFI and ignition management with a new Haltech ECU. Can I plug an E6X into the existing wiring for the F3? If not, can I use a terminated loom kit with the 5-cyl, or do I need the flying lead kit? Any and all advice I can get would be appreciated.


Re: Replacing my ancient Haltech on a 5-cyl Turbo

Postby THR RX7 » Tue May 16, 2006 10:31 am

The terminated harnesses for the E6X are available for an additional cost over the flying lead kit, i am not aware if there is a terminated option for the E8/E11, but usually that termination isnt matched to a specific vehicle, its just all the connectors done on the harnesses and heat shrink tubing on the wires. For your 5 cylinder i would suggest the E8, or if you are on a budget, the E6X, but im not sure on the proceedure for 5 cyl engines.

Contact haltech directly for info from them on it.
Claudio RX-7
For RX-7's and the Performance Markets
[email protected]
Dominican Republic
Tel. +1(809)763-0202

Return to “General Discussion (from EZBoard)”

Who is online

Users browsing this forum: No registered users and 1 guest