I recently installed the pro-plugin ECU with the AUX harness in place of my redbox for flexfuel. I wired my haltech dual wideband (Haltech HT010705) to the ECU directly.
two grounds to signal ground Pin#12
red power to +13.8v Pin#16
white signal to AVI 3 Pin# 10
blue signal to AVI 4 Pin# 11
In the software, I have set the auxiliary in the main setup for the avi3 to wideband 1 and avi4 to wideband 2.
When I turn on the car the reading is at 10.0, .02 v. I used a meter to measure the voltage for the power on Pin#16 and is it fluctuating between 11 and 13.7. Can the ECU power up the wideband or does it need a relay setup. I had no issues with the wideband on the redbox when it was directly wired up for power.
I tested out the wideband by wiring it directly to the battery and I had normal a/f readings. Does the wideband draw so much power that i need to run a relay setup or is there something wrong with the AUX power?
Questions about the Platinum Pro Harness 350Z and R35? Ask here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests