Page 1 of 1

MAP for 3sgte?

Posted: Thu Jul 30, 2015 2:37 am
by kpsxtyone

I got the PS1000 setup on the 3sgte 3rd gen basically a stock motor with 540CC injectors.

I got it running but it keeps dying when i try to drive it out the driveway.

Anyone can share a map for it?
I think i got the basics setup like sequential injection and sequential ingnition. check to make sure that when i lock the timing to 10 deg i get the same on the pulley.

I also tried the fuel and timing map only from the default MAP folders for the Totoya/2JZ but no luck


Re: MAP for 3sgte?

Posted: Fri Jul 31, 2015 11:14 am
by ausjd2703
I had a stock gen 3 running on a haltech gen 2 map.
just change the injector size and you may possibly need to trim the fuel. ran well enough to drive the car onto the dyno. I wouldn't recommend any more than this, you also need a wideband to trim the fuel out other wise it runs rich but will run.

Re: MAP for 3sgte?

Posted: Fri Aug 14, 2015 11:16 pm
by kpsxtyone
Thank you!