BK theta shows high battery voltage. Need help.

Questions about the Platinum Pro Plug-in ECU's? Ask here.
Dekarsan
Posts: 1
Joined: Sun Aug 23, 2020 3:34 pm

BK theta shows high battery voltage. Need help.

Postby Dekarsan » Sun Oct 18, 2020 4:20 am

Hi!

I have installed my new haltech pnp ECU and ecu manager 1.14 shows my battery voltage reading 18,5v and its constant, does not go higher or lower however much load i put on the car. Measuring at the battery voltage when car if off and on i get 12.5v and 14.4v respectively.

I have rerouted the ecu to the cabin as instructed by manual and chosen the same ground position as in the instructions... i ran my stock ecu from same rerouted spot before switching to a haltech and by measuring with obd scanners it showed the correct voltage.

I have an European(sweden) sold Genesis coupe, dont know if it matters on how the pins are wired on the stock harness.

Return to “Platinum Pro Plug-in”

Who is online

Users browsing this forum: No registered users and 3 guests