Hi - I tried installing a can hub to run a can gauge and WB1 plug in. I am not getting any readings at the gauge. When loading the ecu manager, it reads the wb1 and ecu runs fine. However, gauge is not reading any measurements. I have the resistor in place since it’s the last in the chain.
Can hub set up:
Slot 1 is ECU with black/black
Slot 2 is WB1 with white/white
Slot 3 is Can gauge with tyco adapter harness with black end - terminator resistor is in place.
What am I missing to get this gauge to read?
Ecu is R32 GTR platinum pro plug in.
Questions about the Platinum Pro Plug-in ECU's? Ask here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests