I bought Haltech P&P for 350Z and my engine does not want to work. I found out that there was a problem with the camshaft sensors. I ordered a new original Nissan (23731-6J90B and 23731-AL61A), after installing the Haltech began to show engine speed when rotating with a starter, but it would not start.
Began to check the ignition, sparks only 3 cylinder. Having connected the oscillograph I saw that the patterns are turned over for VQ35DE. It is not possible to specify patterns in this version the computer firmware.
What do I need to do to make my engine work?
Questions about the Platinum Pro Plug-in ECU's? Ask here.
2 posts • Page 1 of 1
- Haltech Staff
- Posts: 2912
- Joined: Tue Feb 07, 2012 12:45 pm
- Location: Sydney, Australia
Who is online
Users browsing this forum: No registered users and 5 guests