Wideband analog input not working

Questions about the Platinum Pro Plug-in ECU's? Ask here.
s57_s2k
Posts: 7
Joined: Tue Mar 05, 2019 9:56 am

Wideband analog input not working

Postby s57_s2k » Tue Mar 05, 2019 10:16 am

Hello

I can not get my 350z ECU to read my analog input from my wideband controller its always shows my AFR is fixed at 12.8 . I am using pin #2 AV1 input for signal and pin #4 for signal ground . I have confirmed that my wideband output voltage is working using volt meter. I didn't click on pull-up box.

What could be the problem ? do I need to use a resistor ?

s57_s2k
Posts: 7
Joined: Tue Mar 05, 2019 9:56 am

Re: Wideband analog input not working

Postby s57_s2k » Wed Mar 06, 2019 3:09 am

I found the problem the I/O connector was crimped wrong. :mrgreen:

User avatar
HaltechMatthew
Haltech Staff
Posts: 2909
Joined: Tue Feb 07, 2012 12:45 pm
Location: Sydney, Australia
Contact:

Re: Wideband analog input not working

Postby HaltechMatthew » Wed Mar 06, 2019 1:37 pm

Good that you reported it rather than say nothing. :mrgreen:


Return to “Platinum Pro Plug-in”

Who is online

Users browsing this forum: No registered users and 3 guests