R32 GTR: Can the Platinum Pro plug and play work on aftermarket boost sensors and control unit? (boost controller off)

Questions about the Platinum Pro Plug-in ECU's? Ask here.
232GTR
Posts: 1
Joined: Fri May 15, 2020 6:19 pm

R32 GTR: Can the Platinum Pro plug and play work on aftermarket boost sensors and control unit? (boost controller off)

Postby 232GTR » Fri May 15, 2020 6:31 pm

I'm looking to install a plug and play into my R32 gtr and run a base map, however my car currently has an HKS EVC-S boost controller installed which I want to turn off.

I have attached a diagram of the HKS boost controller set up.

I have a few questions:

1. Can the Ecu take control of boost and read from the HKS unit?

2. Do I have to reinstall stock or Haltech sensors and solenoids, for the Haltech to control the boost. Or can I reuse the HKS sensor to the Haltech?

3. If the Haltech unit can run and control the boost off the aftermarket boost controller sensors. Will I be able to increase the boost up to 1 bar safely without a tune?

Which Haltech solenoid for an rb26dett?

Thanks in advance!
Attachments
Screenshot_20200515_201813_com.android.chrome.jpg

Return to “Platinum Pro Plug-in”

Who is online

Users browsing this forum: No registered users and 2 guests